Mag Hitch Pro
The World’s First Magnetic Hitch Holder
Patent-pending. Drop-tested. Installs in seconds. Holds your hitch rock solid
Designed, printed, and assembled by hand in Owego, NY by Chris Bercaw — Print Tweak Build Industries LLC
THE PROBLEM
Your hitch doesn’t belong on the floor.
Every truck owner knows the drill. You disconnect your hitch, toss it in the bed, and for the next 50 miles it slides around, bangs into everything, and ends up wedged under your toolbox or rolling into your tailgate. Then you drop the tailgate and it goes straight for your shins.
Most guys just live with it. A few drill holes. Neither is a good answer.
The Mag Hitch Pro was built to end it.
The Product
Snap it. Slide it. Done.
No straps. No drilling. No rattling around. Press the Mag Hitch Pro flat against any steel bed wall and slide your hitch in. Four bolt-in neodymium magnets hold it exactly where you put it — through rough roads, highway speeds, and daily driving. Real-world tested for a full week with a loaded draw hitch. It didn’t move.
The magnets are bolted in, not glued. If one ever needs replacing you can swap it yourself with no special tools.
Built from industrial-grade PETG. Designed and handmade in Owego, NY.
CHOOSE YOUR SIZE
Two hitches. Two holders. One solution.
Mag Hitch Pro — For 2” Hitches
Three bolt-in 120-lb neodymium magnets. Dedicated 2” receiver slot. No rattle, no slop. $84 This weekend only!
Mag Hitch Pro HD — For 2.5” Hitches
Four bolt-in 120-lb neodymium magnets. Built for heavier setups. Larger footprint, stronger grip.
$127 This weekend only!
WHAT YOU NEED TO KNOW
Will it work on my truck?
It mounts to flat steel bed walls. That’s it. If a magnet sticks to your bed wall you’re good. If your bed is aluminum or you have a thick rubber liner with no steel contact, it won’t work without a steel plate added first. Ford aluminum beds — BoxLink version is in development. Stay tuned.
Needs approximately 7.5” wide × 11.5” tall of flat unobstructed steel surface for the HD, or 10.5” × 3.5” for the standard Pro.
F.A.Q
Will it hold while I’m driving?
Yes. Tested with a loaded draw hitch for a full week of daily driving. Zero movement.
Are the magnets glued in?
No. Every magnet is bolted into a molded nut trap. Field replaceable with no special tools.
What about theft?
If you have a tonneau cover, bed cap, or any bed enclosure — your hitch is out of sight and out of mind. A standard hitch lock pin through the receiver hole adds extra security if you want it.
Does it work with spray-in liner?
Yes. Factory spray-in liner is fine as long as it’s not extremely thick and the magnets still contact steel underneath. Test with any magnet first.
What about Ford aluminum beds?
Not yet. A BoxLink compatible version is in development. Message us to get notified when it’s ready.
⚠️ PINCH HAZARD: These magnets are serious. Keep fingers clear when placing on steel. May require two hands to remove. Keep away from pacemakers, implanted medical devices, and sensitive electronics.
Stop losing your hitch to the bed floor.
Made to order in Owego, NY. Patent pending. Ships within 7-10 business days.
Or visit the full Print Tweak Build shop at printtweakbuild.com